Aerial Media Pros is now part of Enterprise UAS. For more information visit EnterpriseUAS.com
Request a quote for
Need a Proposal or Have a Question? Please fill out the form below
and one of our aerial experts will be in touch immediately.
This camera sees Infrared (IR) Light, which our eyes cannot see, yet plants reflect. Often used in NDVI analysis for comparing to a Red Light camera or in ENDVI with separate Red and Green Light cameras.
The MAPIR Infrared Light Camera captures a photo every 3 seconds. For best results, we recommend a survey overlap of at least 85% front-lap and 70% side-lap and a maximum 5mph (8kmh) speed for every 65ft (20m) of altitude (AGL).
This package contains 4 ground targets that each have known reflectance curves. The target material is composed of a felt-like material mounted to a plastic substrate. It can be captured from any angle with your camera thanks to similar total and diffuse reflection properties.
To use this target, before each flight, take a photo using each camera of the entire open package with the targets facing straight up (though no shadows on the entire target area). You would then use these images in MAPIR's post-processing software to calibrate the index image pixel values. This will further improve the normalization of your surveys over time and locations. Full capturing tutorial here.
The material used for the targets is similar to felt and thus must be kept debris-free to properly work. We recommend holding your drone over the target or taking off away from it and then hovering overhead in order to reduce the amount of debris that may land on it. A hovering height from 10-15ft is recommended while trying to keep the target in the center of the camera's view. Thanks to the target material's diffuse properties you will no longer need to worry about where the camera is orientated to get good results. The detection pattern (fiducial) is also much lower in resolution, making detecting in MAPIR's post-processing software that much easier, even with images having high noise (typically near-infrared wavelengths). Reflective measurements were made using multiple Shimadzu spectrophotometers incorporating an integrating sphere.
Using MAPIR's Camera Control (MCC) software you can select the photo of this target taken before your survey, the fiducial pattern will be auto-detected and the reflectance value of each target will be calculated and applied to each of your images. The resulting individual images will then be calibrated and you can generate your ortho-mosaic in the software of your choosing. You can also calibrate the entire ortho, or groups of orthos. Using the Viewer tab in MCC you can calculate the rastor/index images (for example NDVI) and then apply your color map (lut).